Cobra SPYBALL 6829 Troubleshooting Guide

1 SPYBALL® 6829 Alarm + Immobiliser Thatcham cat. MC1 SPYBALL® 6809 Alarm Upgrade Thatcham cat. MC2>1 Meeting The British Insurance Indus

10 If the Biker Recognition function is activated, the disarming of the alarm section is also automatic as the biker returns to the pr

11 Movement detection. Triggers the alarm in the event of for example lifting, towing, forcing the steering lock by means of a revolutionary sensor

12 7. ADJUSTMENT OF MOVEMENT DETECTION SENSITIVITY (this is a dealer operation) The movement detector can be adjusted to 8 different levels

13 8.1. Reduction of audible alarm power The volume level of the alarm can be reduced when the motorcycle is parked in areas where noise pollution

14 9. ALARM MEMORY AND DIAGNOSTICS If the security system has been triggered during your absence, upon disarming you will be warned by differe

15 Remark: the same will happen if you leave the range of the transmitter while the ignition of your motorcycle is on. Important:

16 will allow you to temporarily disable automatic arming / disarming and the anti-hijack function without entering the selection procedure (Servic

17 - Anti-hijack function (see paragraph 10) - Polarity of instantaneous alarm trigger input (this selection should be set up by the

18 3 flashes “Turn indicator on” audible warning signal Press push-button n. 1 of the transmitter after the third flash Three (3) sharp audi

19 15. AUTOMATIC TIMED SWITCH-OFF FUNCTION (SLEEP FUNCTION) Although the current consumption rate of Spyball security systems is extremely low, an

2 Table of contents 1. Kit composition 2. Features of the radio transmitter 2.1. Realignment of a transmitter 2.2. Pairing of new transmitters

20 If the full system is armed: 1. Turn ignition on.  The alarm starts to sound. 2. Wait.  The alarm stops. The LED switches off, then it sta

21 ONCE ALL THE DIGITS HAVE BEEN ENTERED CORRECTLY, THE SYSTEM DISARMS WITH A LONG BLEEP AND THEN SWITCHES TO SERVICE MODE (see paragraph 12). 16.

22 Count the flashes. As soon as you reach the number you have chosen as the first number of your PIN code, turn the ignition off. Turn the ig

23 Spyball dealer (in the meantime, if the system is armed, disarm it with the PIN code (see paragraph 16) The alarm/immobiliser is disarmed, but

24 Siren sound power 114dB@1m Size of the control unit 90x67x30mm Size of the transmitter 50x37x12,5 Transmitter battery 3V CR2032 Transmitter bat

25 Warranty This product is protected by a 24-month warranty from the date of purchase as certified by a receipt or an invoice. The warranty

26

27

28 PIN: ……………………………………………………………… EMERGENCY DISARMING VIA PIN CODE If the full system is armed: 1. Turn ignition on.  The alarm starts to sound

3 14. Selectable functions – Enabling and disabling procedures 15. Automatic timed switch-off function (sleep function) 16. Emergency disarming

4 It is powered by a Lithium CR 2032 3V-battery. When the battery is close to flat, the user is warned by an additional flash of the turn indicators

5 Turn ignition on and wait 20 seconds.  The dashboard LED illuminates and remains on about 3 seconds. Before the dashboard LED extinguishes

6 3. BIKER RECOGNITION FUNCTION Besides its operation as a conventional remote control key, the transmitter can be used in Biker Recognitio

7 If you expect to leave this function unused for a long time, you are strongly recommended to at least deactivate it from the transmitter, becaus

8 4.2. Arming / disarming of the full security system without Biker Recognition function (use as a conventional transmitter) To activate the full

9 (*) Three additional sound signals in quick succession indicate that there is an irregularity in peripheral protection (e.g. the seat is open, t