Cobra CPI 850 User Manual download pdf (Page 52)

Section 5: Solving Problems

52 AXIS 370 Cobra User’s Manual

Error messages

There are five different error conditions that will cause the AXIS 370

Cobra to print an error message on your printer:

This message indicates that the non-volatile memory has been

corrupted. The interface is automatically set to factory default state

(your configuration is lost). If the message does not re-appear after

power-off/power-on, configure the AXIS 370 Cobra (Section 3).

The available string area is exhausted. You must remove some strings

from your configuration. (User Definable Strings, String Substitutions

or String parameters in the Parameter List). The size of the available

string area is printed in the Parameter List header, and is also displayed

in all string programming menus.

Incorrect or insufficient bar code definition. The bar code must be

specified with five values. See “Bar Codes” on page 44.

The software cannot run in the current hardware. Contact your

dealer.

An attempt has been made to enable GDDM (#142) with insufficient

free memory. You must remove some strings from your configuration.

(User Definable Strings, String Substitutions or String parameters in

the Parameter List). The size of the available string area is printed in

the Parameter List header, and is also displayed in all string

programming menus.

E2-PERMANENT MEMORY CHECKSUM ERROR, FACTORY DEFAULTS SET

E6-MEMORY OVERFLOW: FREE STRING AREA EXHAUSTED

BE-BAR CODE ERROR

BD-SOFTWARE/HARDWARE ERROR

BF-GDDM SUPPORT NOT ENABLED: NOT ENOUGH ROOM IN FREE

STRING AREA; 3352($0D18) BYTES REQUIRED

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 73 74

No comments

Cobra CPI 850 User Manual Page 52