Cobra Combi Operations Instructions download pdf (Page 15)

Checking for wear on the tool shank

108mm

22mm

Use the gauge that corresponds to the insertion tool’s

shank dimension. See section "Technical data" for

correct tool shank dimensions.

Fitting and removing the insertion tool

Whenever fitting or removing the insertion tool the

following instructions must be observed:

1. Stop the machine and wait until the inserted tool

has cooled down.

2. Fit or remove the insertion tool.

3. Close the tool retainer by using your foot.

WARNING Vibration hazard

Using inserted tools that do not fulfil the criterias

mentioned below, will result in a longer time to

complete a task, and may result in higher levels of

vibration exposure. A worn tool will also cause

increased working time.

► Make sure that the inserted tool is well-maintained,

not worn out and of the proper size.

► Always use a sharp tool in order to work efficiently.

Operation

WARNING Involuntary start

Involuntary start of the machine may cause injury.

► Keep your hands away from the start and stop

device until you are ready to start the machine.

► Learn how the machine is switched off in the event

of an emergency.

Original instructions

Safety and operating instructionsCOBRA COMBI

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

No comments

Cobra Combi Operations Instructions Page 15