Cobra Combi Operations Instructions download pdf (Page 18)

When taking a break

♦

Stop the machine during breaks.

♦

During all breaks you must put the machine away

so that there is no risk for unintentional start.

Maintenance

Regular maintenance is a basic requirement for the

continued safe and efficient use of the machine.

Follow the maintenance instructions carefully.

♦

Before starting maintenance on the machine, clean

it in order to avoid exposure to hazardous

substances. See “Dust and fume hazards”

♦

Use only authorised parts. Any damage or

malfunction caused by the use of unauthorised

parts is not covered by warranty or product liability.

♦

When cleaning mechanical parts with solvent,

comply with appropriate health and safety

regulations and ensure there is satisfactory

ventilation.

♦

For major service to the machine, contact your

nearest authorised workshop.

♦

After each service, check that the machine's

vibration level is normal. If not, contact your

nearest authorised workshop.

Every day

Before undertaking any maintenance or changing

the inserted tool, turn the machine off.

♦

Clean and inspect the machine and its functions

each day before the work commences.

♦

Perform a general inspection and check that there

are no leaks and no damage.

♦

Check the electrical cabels and electrical

insulations for wear, change if necessary.

♦

Check that the O-ring on the oil plug is undamaged

and seals properly.

♦

Check that the oil plug is tightened regularly.

♦

Check the insertion tool, make sure that it is sharp

and not worn out.

♦

Change damaged parts immediately.

♦

Replace worn components in good time.

In order to ensure that the machine remains within

the stated vibration level values, the following checks

must be performed:

Every year

Overhauling must be done after one year of

continuous operation. Overhauling must for safety

reasons be performed by authorised personnel at an

authorised workshop.

Repair

Replacing the starter cord

WARNING Spring tension

The starter spring may cause personal injury by

striking the operator or other persons.

► Wear impact resistant eye protection with side

protection and gloves.

Removing the old starter cord

1. Remove the screw-cap of the PTO and the three

bolts from the protective cover of the starting

mechanism.

2. Lift off the cover, grasping the starter pulley as

well. Let the cover rotate carefully against the

starter pulley, to release the spring tension.

3. Remove the old starter cord.

Original instructions

COBRA COMBISafety and operating instructions

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Cobra Combi Operations Instructions Page 18

Comments to this Manuals

Related products and manuals for Power drills Cobra Combi