Cobra PR 1100 User Manual download pdf

Laser Disc Player Conversion Card

Design and Firmware by Shaun D. Wood

[email protected]

Cliff Hanger Installation Instructions

The LaserCon LDP Converter is an adaptor card for the replacement of your broken

laserdisc player, to a newer, faster, more reliable one. These instructions are for Cliff

Hanger and the CH conversions of Cobra Command and Goal to Go.

Parts List

LaserCon board, Replacement Player Interface Cable and these Instructions.

Supported Replacement Player: Pioneer LD-V8000

Installation Instructions

1. Verify your LaserCon board is ready for 8210/LD-1100 use.

Version 1.X of the LaserCon LDP Conversion board was not configured to work with games using the

the PR-8210/A or LD-1100 Laserdisc players. If you have one of these earlier boards and wish to

modify it for use with the PR-8210, download and follow these instructions first...

If your game uses:

IR remote at the front of the player: http://wood1st.com/LaserCon/Docs/LC_Conv8210IR.pdf

A direct wire into the back of the player: http://wood1st.com/LaserCon/Docs/LC_Conv8210plug.pdf

If your LaserCon is properly configured for PR-8210 use, then continue.

2. Configure your new player:

Baud Rate: 4800, No Parity, 1 stop bit, Data Length: 8 bits,

TxD terminator: <CR>.

Connect the player to a TV or monitor.

Press and hold the “DISPLAY” button while powering-on the player.

Press “SCAN FORWARD” to reach Page-5 “RS-232 SWITCH P-5”

press “STEP FORWARD” to highlight an item, then

press “STEP REVERSE” to change the setting.

Set: Baud Rate: 4800, No Parity, 1 stop bit, Data Length: 8 bits

1 2 3 4 5 6 7

Summary of Contents

Page 1

Laser Disc Player Conversion Card Design and Firmware by Shaun D. Wood [email protected] Cliff Hanger Installation Instructions The LaserCon LDP Co

Page 2

3. Install the LD-V8000 player into the game cabinet. Remove the 'Y' connector and use 2 separate video cables. Attach “Video Out #1” to Vi

Page 3

Make sure that the player’s power switch is pressed in (ON). 4. Set Dipswitches: On LaserCon, set switch …. 1 2 3 4 ON OFF OFF OFF

Page 4

5. Install the LaserCon card: (if doing a direct-wire install, skip ahead to B.) A. IR Remote-Control install: Remove the connector from the I

Page 5

Find the test points on the power supply board. Cover all of the loops except "GND". Attach the Alligator clip from the LaserCon board to

Page 6 -

In Direct Wire mode, your LaserCon board needs to connect to +5Volts. The alligator wire must match this photo... Find the +5Volt test

Page 7

6. Connect the serial cable to the laserdisc to LaserCon's 9-pin connector (CN2). 7. Mount the LaserCon board to any convenient spot within the

Cobra PR 1100 User Manual

Browse online or download User Manual for Two-way radios Cobra PR 1100. CH Set-up Instructions for The LDP Converter

Summary of Contents

More documents for Two-way radios Cobra PR 1100

Comments to this Manuals

Cobra PR 1100 User Manual

Browse online or download User Manual for Two-way radios Cobra PR 1100. CH Set-up Instructions for The LDP Converter

Summary of Contents

More documents for Two-way radios Cobra PR 1100

Comments to this Manuals

Related products and manuals for Two-way radios Cobra PR 1100