Section 4: Advanced Functions
AXIS 370 Cobra User’s Manual 31
1001010100111
11010001001
010011101
Redefine Configuration and Transparency Sequences
The Start and Stop Transparency and Configuration are controlled by
three string parameters:
• Transparency Lead-In Sequence (#070), default ‘%%’.
• Configuration Lead-In Sequence (#071), default ‘%P’.
• Transparency/Configuration Trailer Sequence (#072), default ‘%’.
See Appendix A for a description of the parameters. The parameters
can be redefined using Configuration from the System.
Document Example:
Change the Transparency Lead-In Sequence from ‘%%’ to ‘!?<’
(DBC codes $19,$18,$09). Also, change the Trailer Sequence
from ‘%’ to ‘>&’ (DBC codes $08,$30):
Notes: ❏ To redefine the sequences, Extended Emulation Mode must be
entered. The sequences are reset to their default values if you exit
and re-enter Extended Emulation Mode.
❏ The sequences are redefined immediately. Therefore, the new
sequence ‘>&’ must be used as Configuration Trailer Sequence in
the document.
Document Example:
Use the new sequences in the same example as in the previous
section (Multi-byte Transparency):
This results in the same printout as in the previous section.
%P (Configuration lead-in sequence)
=70,$19,$18,$09 (Change the transparency lead-in sequence to ‘!?<’)
=72,$08,$30 (Change the configuration trailer sequence to ‘>&’)
=207,10 (Initialize settings)
=207,12 (Save settings permanently)
>& (Configuration trailer sequence (new
))
This is !?<1B2D31>&underlined!?<1B2D30>& text
Comments to this Manuals