Cobra CT6 Specifications download pdf (Page 12)

Part 6 Gas Conversion

Pilot Burners

1. Disconnect pilot supply and thermocouple tubes

from the gas control valve.

2. Undo the 2 screws securing the pilot assembly to

the griddle toaster main frame.

3. Withdraw the pilot assembly, remove the existing

pilot injectors and replace with the correct size

injectors.

4. Repeat for the second pilot burner.

5. Re-assemble the pilot burners to the griddle

toaster.

6. Refit the main control panel.

Low Fire Adjustment

1. Set the burner low fire adjustment. The low fire

screw on the gas control valve should be

screwed fully 'In', then unscrewed by the

measurement shown in the “Gas Specifications”

table at the end of this section.

NOTE:

The “Low Fire Adjustment Screw” should be sealed

with coloured paint on completion of the low fire

adjustment.

2. Refit the front control panel and secure in

position by tightening the 2 screws on the front

lower edges of the control panel.

3. Refit the gas control knobs to the gas control

valves. The gas control knobs are a push fit onto

the shaft of the gas control valves.

Gas Conversion Procedure

NOTE:

 These conversions should only be carried out

by qualified service persons. All connections

must be checked for leaks before re-

commissioning the appliance.

 For all relevant gas specifications refer to the

table at the end of this section.

Main Burners

1. Ensure that the gas supply has been turned 'Off'.

2. Remove control panel and toasting rack.

3. Unscrew the wing nut at the rear of burner and

lift out the burner.

4. Determine correct injector sizes for the

corresponding gas from the table shown in the

'Gas Specifications' section.

5. Remove the injectors from the injector support

bracket.

6. Replace with the correct size injectors.

7. Repeat for the second main burner.

8. Refit the main burners to the griddle toaster.

AUTION

Ensure that the unit is isolated from the gas

supply before commencing servicing.

Wing Nut

Main Burner Injector

Thermocouple

Connection

Pilot Securing Screws

Pilot Gas Supply Tube

Low Fire Adjustment Screw

1 2 ... 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Cobra CT6 Specifications Page 12

Comments to this Manuals