Cobra CT6 Specifications download pdf (Page 5)

Gas Connection

Gas supply connection point is located 130 mm

from the right hand side of the appliance, 32 mm

from the rear and 655 mm from the floor and is

entered from beneath the appliance.

Connection is ½” BSP male.

Dimensions

CT6 Gas Griddle Toaster (600 mm)

Part 2 Specifications

Model Covered in this Specification -

CT6 Gas Griddle Toaster.

General

A commercial heavy-duty gas fired griddle toaster,

having two tubular burners heating a griddle plate

from underneath and providing toasting heat for

the toasting rack below.

Burners are operated by individual control valves

and are provided with a piezo ignition permanent

pilot incorporating a thermocouple flame failure

control.

Gas Supply Requirements

- Non - UK Only:

- UK Only:

NOTE: (*)

The burner operating pressure is to be measured at

the manifold test point with all burners

operating at

full setting. The operating pressure is ex-factory set,

through the appliance regulator and is not to be

adjusted, apart from when converting between

gases, if required. (Refer to the ‘Gas Conversion’

Instruction Sheet' for this appliance for further

details).

Natural Gas

LP Gas

(Propane)

Input Rating

42 MJ/hr 42 MJ/hr

(N.H.G.C.)

(39,800 Btu/hr)

Supply Pressure

1.13 - 3.40 kPa 2.75 - 4.50 kPa

(4.5” - 13.5” w.c.) (11” - 18” w.c.)

1.00 kPa (*) 2.50 kPa (*)

(4.0” w.c.) (10.0” w.c.)

Gas Connection

½” BSP Male

Burner Operating

Pressure

Nat Gas

(G20)

Propane

(G31)

Heat Input

(nett)

Nominal

11.0 kW 11.0 kW

Reduced

6.0 kW 5.6 kW

Gas Rate

(nett)

Nominal

1.16 m

/hr 0.85 kg/hr

Reduced

0.63 m

/hr 0.44 kg/hr

Supply Pressure

20 mbar 37 mbar

Burner Operating

Pressure

10 mbar (*) 26 mbar (*)

Gas Connection

” BSP Male

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments

Cobra CT6 Specifications Page 5

Comments to this Manuals